KAMEN RIDER TOY WEB

BANDAI official KAMEN RIDER toy information site

Updated: March 20, 2023

KAMEN RIDER Development Blog

MASKED RIDER KUUGA

KAMEN RIDER GEATS

CSG 2nd release! Pegasus Bowgun to be commercialized!!


Hello everyone. This is Funasen, the CSM representative.

It was announced yesterday! The second installment of "COMPLETE STYLE GIGANTIC" has been decided to be the "CSG Pegasus Bowgun" without any twists and turns!!!
This will be the second consecutive release since Kuuga.



I think that the Titan Sword has done a good job of conveying the fun of this brand item!
One thing I learned while developing Titan Sword was that there are toys that exist solely on the basis of their volume.
In fact, when the Pegasus Bowgun is equipped with the rising parts, it becomes quite large in size, rivalling the Titan Sword... or maybe even larger?
We hope you look forward to it!


Next up, we have the final information on the "HENSHIN BELT DX Vision Driver," the first batch of which will be shipped next week!
The reservation page design has been updated! In light of yesterday's broadcast, we have updated it to reflect the "transformation into Glare 2" and "Rider hijacking & forced armament" features.
Please take a look! The Glare 2 at the top of the page is the Beloba version.



Reservations will be accepted until April 10th. Thank you for your continued support.

Also, there are a few things we would like to explain in advance about the appearance of the Vision Driver, so please see below.

① Vertical lines seen in the horizontal light emitting area



In the photo above, among the many luminous lines glowing horizontally, there are countless vertical lines; however, these are not scratches but an intentionally roughened finish known as "grain."
This allows the LED light entering from the side to remain on the surface, making it appear as if it is emitting light in a horizontal line.
Therefore, we would like to inform you in advance that this is not a scratch and hope to avoid any misunderstanding.


② Driver - Regarding the slightly recessed parts on the four corners



This is called a "sink" (which is found in most toys) and is an unavoidable part of the molding process.
So please understand that this is not a scratch.

Thank you for your cooperation.


Finally, as we announced in our last blog, starting at 10pm tonight we will be streaming a live show called "Pre-Band Lab Lβ"!
There will be samples that will be shown for the first time on this program, so if you have time, be sure to check it out!


That's all for today's blog. The next update will be on Tuesday, March 28th.
The next blog post will be updated within this week. We apologize for the inconvenience.

Well then!
share
X
Facebook
LINE

Related topics